INSTALLING THE BATTERIES AND SD CARD
Before you begin learning how to use your Trophy Cam, you will first need to install a set of batteries and insert an SD card. Although that may only take you a minute, there are some important notes about both batteries and SD cards you should be aware of, so please take the time to read the following directions and cautions:
Loading Batteries
After opening the two latches on the right side of the Trophy Cam, you will see that the Trophy Cam has eight or twelve battery slots, depending on your model. For maximum battery life, you should install a full set of batteries. The Trophy Cam may also be operated by just four batteries installed in the first slots only (starting on the top or
Bushnell recommends using a full set of new lithium
AA(Energizer® brand) or alkaline AA batteries. NiMh Rechargeable batteries are not recommended, as the lower voltage they produce can cause operational issues. It is also possible to use a
Using an External Power Source (optional, user provided)
Optionally, you can connect an external 6V DC power source to the “DC In” jack at the bottom of the Trophy Cam. It is recommended to use a power source with a current output greater than 1550mA. However, during bright daytime operation when no flash is required, the Trophy Cam can function with much less current ( >400mA). Please use a compatible power source cable (not provided) to connect the external DC power source with the power input jack of the Trophy Cam, making sure that the polarity is correct. Note: The power connector is a 4.0x1.7mm coaxial DC power plug with positive “tip” (inside pin) polarity (Radio Shack P/N
6
