14 Features in sb275a02 Software Maintenance Release Note
Version sb275a05
C613-10464-00 Rev H
Level 3
CR Module Level Description
CR00009379 Appletalk 3 When the switch was using AppleTalk, it occasionally failed to process
traffic. When this occurred, entering AppleTalk commands could cause
the switch to rebo ot.
This issue has been resolved.
CR00010377 Switch 3 Inserting a slave control card into slot A of a SwitchBlade chassis reduced
the number of external IP and IPX interfaces that could be created on all
line cards.
This issue has been resolved. The insertion of a slave control card into slot
A of a SwitchBlade chassis now does not change the number of external
IP and IPX interfaces that can be created on all line cards.
CR00010798 GUI 3 The web-based GUI enables users to manage switch ports by using icons
to represent each port. Previously, for 8-port line cards, alternating RJ-45
port icons did not display.
This issue has been resolved.
CR00011308 File, Install 3 On the slave switch controller, the list of files that the command show file
displayed sometimes included two entries for the file temp.ins. This file is
part of the switch’s management of temporary install records.
This issue has been resolved. The command now correctly shows only one
entry for temp.ins.
CR00011774 Switch 3 The dot1qTpFdbPort MIB entry displays the ports on which the switch has
learned MAC addresses. Previously, the switch started the list of ports at
port 0 instead of port 1.
This issue has been resolved.
CR00011849 Alarm 3 When a port was disconnected, the “Port Failure” indicator on the GUI
remained in alarm state until the port was reconnected. This gave the
incorrect impression that an alarm condition existed.
This issue has been resolved.
CR00012323 Switch, VLAN 3 Ports were not always numbered correctly in the SNMP tables
dot1dStpPortTable, dot1dTpPortTable, dot1qPortVlanTable,
dot1dBasePortTable, and swiPortTable.
This issue has been resolved. The switch now numbers ports in these
tables consistently, with the correct indexes.
CR00012609 IP Gateway,
Switch, VLAN
3The switch sometimes flooded IGMP packets that were destined for the
All Routers multicast address, instead of transmitting them correctly. This
occurred when the switch had a ha rdware filter w ith an action of forward
and the filter matched on packets with a source IP address in a particular
subnet.
This issue has been resolved.
CR00012651 IP Gateway 3 When the switch used IP filters, it dropped packets if they were routed out
the interface on which they arrived, or if they were routed between two
different logical interfaces in an interface (such as vlan2-1 and vlan2-2).
This issue has been resolved. The switch now forwards packets correctly
when IP filters are configured.