4 Features in sb275a05 Software Maintenance Release Note
Version sb275a05
C613-10464-00 Rev H
Level 3
Level 4No level four issues
CR00015071 IP Gateway 2 Routing over a PPP interface could fail if the switch had a default route out
an Ethernet port. The default route switched all packets, even those
destined for the PPP interface.
This issue has been resolved. The resolution involves adding routes over
the PPP interface to the switch hardware tables with an instruction to trap
these packets to the CPU. Therefore these routes now appear in the
hardware tables, and can be displayed by using the command show
switch table=ip.
CR00015132 Switch
GUI
2If a trunk group did not have any ports associated with it, viewing the
Trunk page in the GUI caused the switch to reboot.
This issue has been resolved.
CR00015190 Switch 2 When multicast data was being forwarded at L2 through the switch
during startup and a slave switch controller was present, the switch
sometimes rebooted.
This issue has been resolved.
CR00015697 Switch 2 Mirroring the traffic on port 1 of any line card caused the switch to lose
packets.
CR Module Level Description
CR Module Level Description
CR00011444 Asyn 3 If information was sent to a console (asyn) port that had no cable plugged
into it, excessive C PU usage occurred.
This issue has been resolved.
CR00012858 DHCP 3 Previously, it was not possible to have multiple static DHCP entries with the
same client ID (MAC address), even if the static entries were for different
DHCP ranges.
This issue has been resolved. You can now add static DHCP entries for a
given MAC address to multiple ranges. Note that you cannot have
multiple entries for a given MAC address on the same range.