10 Features in sb275a04 Software Maintenance Release Note
Version sb275a05
C613-10464-00 Rev H
CR00012774 IP Gateway,
TCP
4In an unusual network configuration where the IP subnet on one interface
was a subset of that on another interface, it was possible for the results
of a trace route to show erroneous information.
This issue has been resolved. A search for an interface using an address
within the interface's subnet now finds the most specific match for the
address.
CR00012946 Log 4 When a user entered the command show log receive=ipadd,
information about all IP addresses was displayed unless the user also
entered the mask parameter.
This issue has been resolved. Specifying an IP address without a mask now
limits the display to information about that IP address.
CR00013332 Core 4 When insuffic ient arguments were en tered in the command set
interface, an error message was not produced.
This issue has been resolved, so that an error message is now correctly
output.
CR00013334 TCP 4 The delete tcp command did not output a success message after
successfully completing.
The enable tcp debug command produced messages with the wrong
module ID.
These issues have been resolved.
CR00013336 Core, NVS, TCP,
TTY
4If parameters were incorrectly entered twi ce in some set or show
commands, the resulting error message was corrupted and included
meaningless characters.
This issue has been resolved.
CR00013442 Switch 4 When the user attempted to enable CPU Tx health checking on an
instance in the SwitchBlade controller (by using the command enable
switch healthch eck=cputx ), the switch corre ctly rejected t his command.
However, the output of the show config dynamic or create config
commands included this rejected command.
This issue has been resolved.
CR Module Level Description