Mio Modero IR
16 Mio Modero Device Family
Wiring and Installation
Set the receive AxLink device number before installing the Mio Modero IR. FIG.12 illustrates the
location of key components on the Mio Modero IR circuit board.

Setting the AxLink Device Number

1. If connected, disconnect the power supply.
2. Locate the 8-position Device DIP switch (FIG.12).
3. Set the DIP switch according to the DIP switch values shown below.
The device number is set by the total value of DIP switch positions that are ON (up).
As an example, the DIP switch in FIG.13 defines device number 129 (1+128=129).
If you later change the device number, remove and reconnect the AxLink power connector to enter the
new device number into memory.
FIG. 12 Location of key components on the Mio Modero IR circuit board
Switch12345678
Value 1 2 4 8 16 32 64 128
FIG. 13 Example Device DIP Switch set to 129
AxLink
3.5 mini Phoenix
connector
Notch to pry
faceplate free
(Rear Single)
8 position mini
DIP switch
Screw
holes
PWR+