AMX Device Family Changing Buttons

Installation

6 Mio Modero Device Family

Changing Buttons

The Mio Modero Classic and Elite are shipped with "installation" buttons; they are intended to be place

holders until your engraved buttons, designed with KeypadBuilder, arrive.

To switch out "installation" buttons:

1. Pry the button using the slot on the front of the "installation" buttons to remove them from the Mio

Modero.

2. Select the location of the custom buttons and snap them into place. Be sure to note the orientation of

the white insert on the back of the button, the notch must be down. Insert the bottom of the button

first and then push the top into place.

3. Snap the faceplate on the mounting frame.

FIG. 3 Sections of The Mio Modero

LCD

Mounting

Faceplate

Installation Buttons

Frame

Contents

Main AMX Limited Warranty and Disclaimer Software License and Warranty Agreement Page Table of Contents Page Overview Specifications The Mio Modero device family keypad specifications are as follows: Specifications Available Color Schemes Mio Modero LCD Feature Fixed Menu System Proximity Detection "People Sensor" Page Installation 5 Mio Modero Device Family Installation FIG. 2 The basic front and rear components of the Mio Modero are as follows: Changing Buttons Page Setting The AxLink Device Number Wiring Wiring guidelines Connecting the Wiring AxLink Data and Power Connections Using AxLink for data with an auxiliary power supply Mounting Procedures Page Page Accent Frame Mio Modero IR Mio Modero IR Specifications Wiring and Installation Setting the AxLink Device Number 1. 2. 3. Wiring Guidelines AxLink Data and Power Connections Checking AxLink Status Mounting Procedure Page Page Programming The Mio Modero KeypadBuilder Recognized SEND_COMMANDs Page Page Page Page Sending Firmware to The Mio Modero Keypads