7. Starting up
32
7.3 Settings on the cable tuner
The settings on the cable tuner are made with the RC 815 infra-red
remote-control unit from the place where the AVS 840 Power Receiver is
set up.
Note: the TV AVS 815 Power Transmitter has two separate television
programme memories, one for TV channels and the other for cable TV
channels. You have to do a separate search-tuning scan for each level.
1. Switch on the television set to which the AVS 840 is connected and
select the video input (AV).
2. Switch on the AVS 850 Power Transmitter and the AVS 840 Power
Receiver.
3. The television set will display "RF ID OOO”.
4. Press the "Power” button to switch on the AVS 850 Power
Transmitter.
5. Select the "TV/CATV” button with the level "TV”.
6. Press the "SCAN” button, and the TV will display "PROGRAMME
PRESS SCAN AGAIN”, so press "SCAN” again (within 2 seconds).
7. The automatic search tuning scan (for terrestrial TV transmitters) will
run for the TV level (it takes about 1 minute).
8. Select the level "CATV” with the "TV/CATV” button.
9. Press the "SCAN” button, and the TV will display "PROGRAMME
PRESS SCAN AGAIN”, so press "SCAN” again (within 2 seconds).
10. The automatic search tuning scan for the CATV level (cable TV) will
run.
11. Finished – with the channel section button "CH” you can now page
through all the channels that have been found.
12. To delete channels or to put them back, press the "CH+/-” button
(see description of RC 815, Point 5).
13. The "TV/CATV” button can be used to select either TV or cable TV.
7.4 Changing the coding of the RC 815 remote-control unit
Note: it is only necessary to change the code of the RC 815 remote-
control unit if another TV AVS 815 Power Transmitter is being operated
in your immediate neighbourhood (within about 300 metres).
The basic setting for the code is "000”. To
operate the TV AVS 815 Power Transmitter,
you need the RC 815 infra-red remote-control
unit included with the system.
To avoid switching your neighbour’s Power
Transmitter TV on and off, you can set a code
on the RC 815 remote-control unit and at the
AVS 850 Power Transmitter.
Please proceed as follows:
1. Connect the AVS 840 Power Receiver to
the television set to which the cable signal
is to be sent (see Point 6.2).
2. Take the AVS 850 Power Transmitter,
place it next to the AVS 840 Power
Receiver, and connect only the mains
adapter.
3. Take the RC 815 remote-control unit and
press the buttons "FUNC” and "SET”
simultaneously for about 2 seconds. (The
red LED will flicker when you let go of
them).
4. Use the number keys (0 to 9) to enter a
three-digit code number. Any number is
available between 000 and 255. RC 815 infra-red
remote-control unit