Cables to Go AVS815 manual

5.Press the "SET” button.

6.Switch on the television set connected to the AVS 840 Power Receiver and select the AV input.

You will see the lettering "RF ID XXX" (XXX represents the code currently set on the RC 815 remote-control unit).

7.Disconnect the mains adapter of the AVS 850 from the wall socket for a moment and then insert it again.

8.Point the RC 815 remote-control unit at the AVS 840 Power Receiver and press the "POWER” button.

Now press "POWER” and "SET” simultaneously.

(You have about 30 seconds time for Points 7 and 8). The display on the television screen will now be "RF ID ABC” (ABC represents the code you have now selected).

9.Test the connection by pressing "POWER” (you will only see a glittering pattern on the television set).

10.Connect the AVS 850 Power Transmitter to the cable TV socket again (see Point 7.1).

33

Image 15

Cables to Go AVS815 manual

Contents

Cable Sender Power sender TV AVS815 Thank you very much Contents General functions Safety instructionsGeneral description Correct and proper use Transmissions AVS 850 Power Transmitter Items includedControl elements On / Off switch Channel switchTV channel selection switch Mode switch V Cinch output sockets AVS 840 Power ReceiverConnecting socket for 9 V mains adapter Rear side Use as receiver with channel switching Channel and switch settingsUse as receiver without channel switching Channel switch rear side Infra-red remote-control unit for the cable tuner GeneralControl elements Bringing into operation Connecting the AVS 850 Power Transmitter Connecting the AVS 850 Power Receiver ConnectingStarting up Page Settings on the cable tuner Changing the coding of the RC 815 remote-control unitPlease proceed as follows Page Operating possibilities Fine-tuning the TV AVS 815 Power Transmitter Example 1 Power Transmitter to 3 Power Receivers No transmission Problem RemedyRectifying a malfunction Poor transmission quality UHF Technical data