Installing the AP into a MultiSwitch 900 or DEChub 90
3-4 Installing the RoamAbout Access Point
Seating the AP in the MultiSwitch 900 or DEChub 90
You can install the AP in the MultiSwitch 900 or DEChub 90 without turning off
power. Seating the AP initiates the power-up sequence. However, when installing the
AP into a DEChub 90, connect the console port device to the console port before
applying power to the AP.
Perform the following steps to install the AP in the MultiSwitch 900 or DEChub 90.
Step Action
1Place the AP’s mounting tab into the first mounting slot on the
MultiSwitch 900 or DEChub 90.
2Pivot the AP on the mounting tab and align the connectors.
3Firmly push the AP onto the backplane connectors until the release lever
clicks.
4Press down on the release lever to ensure that it is locked.
5Perform the appropriate steps in “Installing the AP” on page 3-5.
VNswitch 900GV
MultiSwitch 900
DEChub 90
VNswitch 900GV
VNswitch 900GV
Hub Manager
Status Display
Release Lever
Clicks when
Module is
Seated.
Mounting Tab
LKG-9453-941-01