
Configuring the RoamAbout Access Point 4-15
Configuring the AP for LAN-to-LAN
Configuring the AP for LAN-to-LANTo configure two APs to communicate with each other in a LAN-to-LAN
configuration, perform the following tasks:
1) Get the wireless MAC address of the remote AP.
You can see the wireless address via the AP Manager or console device, as
described in “Showing Current Settings” on pa ge 4-4. The wi reles s MAC addr ess
is NOT the same as the wired MAC address printed on the front of the AP.
2) Set the Bridge Mode to LAN-to-LAN, as described in “Setting Bridge Mode” on
page 4-10.
3) Make sure that the APs use the same channel. To change the AP channel, see
“Wireless Parameters” on page 4-6.
4) Set the Transmit (TX) Rate to Auto Select, which is the default setting. See
“Wireless Parameters” on page 4-6 to change the Transmit Rate.
5) Perform this procedure on the other AP.
The following AP parameters are not used in this mode:
•Wireless Network Name
•Secure Access
•AP Density
•Power Management (DTIM Period)