Configuring the RoamAbout Access Point 4-3
Starting a Configuration Tool
You can add all your APs within a wireless domain (defined by the same Wireless
Network Name) so that they show up in one Managed List for future changes. Before
you exit the AP Manager, make sure to save your Managed List file (you will be
prompted). If you are managing APs in multiple domains (d iffe rent Wire les s Network
Names) you should save these APs in a separate file.
Press F1 on your keyboard while in any AP Manager window for information about
the parameters in that window.
Console Port Device
If using a device connected to the AP co nsole po rt, y ou nee d t o acces s the Ro amAbout
Access Point Installation Menu to modify the AP parameters. Perform the following:
The initial installation menu allows you to display and modify the Access Point
parameters. Use the Module-Specific Options menu item to display and modify the
wireless networking parameters.
To prevent other users from accessing the console port menu, choose Enab le/Di sa ble
Console Password from the menu and enable it. Then change the default SNMP
community string as described in “Configuring the AP for SNMP Management” on
page 4-16. Afterwards, the console port will require users to enter the community
string before displaying the menu.
Step Action
1Press Return a few times on the console port device until a menu
appears.
If the AP is connected to a DEChub 90 or is a standalone unit, the
RoamAbout Access Point Installation Menu appears.
Note: If the AP is installed in a DEChub 90, the AP must be powered off
before connecting a cable to the console port.
2If the AP is connected to the MultiSwi tch 900 c onsole port, ch oose Start
Redirect Mode in the MultiSwit ch Installation Me nu. Afterwards, e nter
the AP slot number as shown in the following example.
Enter selection: 9
================================================
Enter the slot number for redirection (1-8): [n]
setup redirected to 3: RoamAbout Access Point