3. With the help of asecond person, hold the Console (11)
near the right Upright (14) as shown.
Insert the Wire Harness (26) into the Right Upright (14).
Route the Wire Harness (26) through the notch in the
bracket on the dght Handrail (2) as shown. Insert the
bracket into the right Upright (14). Make sure that the
Wire Harness is not pinched.
4. Set the Handrails (2) on the Uprights (14) as shown.
Thread a Handrail Bolt (15) with a Handrail Washer (16)
into each Upright and Handrail. Do not tighter= the
Hsndrail Bolts yet.
Tighten a Handrail Screw (32) into the lower end ol each
Handrail (2), Be sure to push on the heads of the Handrail
Screws while tightening them. Next. tighte_ the Handrail
Bolts (15).
5. Attach the Storage Latch (12) 1o the left Upright (14) with
two Latch Screws (13). Be careful not to overtighten the
Latch Screws.
6. Remove the backing from the Adhesive Clip (74). Press
the Adhesive Clip onto the base of the Uprights (14} in
the indicated location. Press the AIMn Wrench (73) into
the Adhesive Clip.
Bracket. _ 12
4
7. Make sure that all parts are tightened before you use
the treadmill, TO protect the floor or carpet, place a
B mat under the treadmgl.