Installing Grills in Barbecue Islands
You will need a second person to help you to avoid damaging the grill, the transformer, or your barbecue island..
Before installing a grill or side burner in any island or cut out, make sure that the opening is not bigger than the outside frame of the grill unit. The grill should rest on the lip of the frame. For
Pay careful attention to the location of gas lines. Gas lines should be routed away from sources of heat and should make as few bends as possible.
Check to see if gas line connections will be accessible when grill is installed.
•If gas line connections are not easily accessible when the grill is installed, support the grill above counter level and attach the gas lines to the grill. When the gas connections are made, slide the grill into the cut out.
•If gas line connections are accessible when the grill is installed, slide the grill into the cut out and then attach the gas lines.
Be very careful not to kink gas lines when lowering the grill or side burner into the cut out.
Keep your fingers away from where the grill will be supported on counter. Your fingers could become trapped and serious injury could occur.
Check to make sure the grill is level and is supported around the entire outside edge. If the grill is not level or is unstable, use
Perform the leak test procedure as described earlier in this manual.
Barbecue Grills
Installing the Rotisserie
Attach the two brackets to the sides of the grill, one on each side, using two screws as shown below.
Slide the rotis motor on one of the brackets as shown below. The rotis motor will work on either side of the grill.
Remove the metal cap protecting the outlet that provides power for the rotis motor. Plug in the motor cord and screw on the retainer nut to keep the plug in place.
9 Installation
LTR50001038, Rev. C | www.calflamebbq.com |
