6
Operating SpaYour
Setting Filtration Cycles
Your spa is programmed to filter twice a day. The first cycle will begin 6 minutes after the spa is turned on and the second cycle 12 hours later. The factory has programmed the cycle to last for 2 hours but this can be switched to 4, 6, or 8 hours depending on your requirements. The default filter time is two hours.
To set filtration time, turn off the power to the spa at the time of day you would like one of the filtration cycles to begin, then turn back on after 30 seconds.
When power has been restored, press either the Up or Down button then the Jets button. Press either the Up or Down button again to change the filtering cycle duration. When desired duration is selected press the Jets button to exit.
The low speed pump will run for the duration of the filtering cycle and if an ozone system is installed it will be activated. During filtering, FC will appear on the main display.
Your new spa comes equipped with an electric heater. Following the directions listed below will ensure the most efficient operation:
NOTE: This method is only for spa usage under two hours a week.
•Keep the spa’s operating temperature 5˚F below the desired usage temperature when not in use. One or two hours before use, set the temperature to the desired temperature.
•If the spa usage exceeds two hours a week, the set temperature should remain at the desired usage temperature.
Allowing the water temperature to lower more than 10˚F below the desired usage temperature and reheating it prior to usage will cause the heater to operate longer than it normally would maintaining the desired temperature. Doing this will increase your operating cost and makes your heater work more than necessary.
2009 Genesis Portable Spa
www.calspas.com | LTR20091058, Rev. A |
