Cal Spas Genesis Portable Spa manual Operating Your Spa, Electronic Control Operation

Operating Your Spa

Electronic Control Operation

Initial Start up

When first powered up, your spa will perform a self-diagnostic check and to into priming mode. The topside will display PR to indicate this. Priming mode will be active for less than five minutes. When the spa has finished priming, the heater will be activated and the water temperature will be maintained in standard mode. The spa will heat to 100°F (37.5°C) at start up until the set temperature is changed as described below.

5 OperatingYour

Temperature Adjustment

(Range 80°F to 104°F, 26°C to 40°C)

The electronic control panel displays the actual water temperature in degrees Fahrenheit. The displayed temperature will only be current after the pump has been running for at least two minutes.

To display the temperature that the spa is set to:

•Press either the Up or Down button. The temperature setting will flash.

•While the display is flashing, each time you press the Up or Down button, the set temperature will change up or down one degree.

Switching Modes

•Press either the Up or Down button followed by the Light button.

•Press the same sequence to switch to the next mode.

Spa

Standard, Economy and Sleep Heating Modes

Your new spa is equipped with a heating feature that gives you complete control of the heating system. When the spa is powered up, it will automatically start in standard heating mode.

•St will light briefly on the main display. In this mode, the heating system will automatically maintain the set spa temperature. In the economy- heating mode, the heating system will only activate during filtration times.

•Ec will display solid if temperature is not current and will alternate with spa temperature if measured temperature is current.

•Economy mode will heat the water to the set temperature while Sleep mode, indicated by a SL on the main display, will also only activate the heater during the filtering cycles but will only heat the water to within 20°F (10°C) of the set temperature. Like Economy mode, SL will display solid when temperature is not current and will alternate with actual temperature when it is current.

Jets

Press the Jets button:

•Once to activate low speed pump.

•Twice to activate high speed.

•Three times to turn pump off.

Light

Press the Light button to turn on the light. Press it once again to turn the light off. All optional lighting such as the control panel light and cabinet perimeter lighting is controlled by the Light button and will turn on and off with the spa light.

Automatic Time outs

These features will automatically turn themselves off during periods of continuous use:

•	Low speed pump	After 2 hours
•	High speed pumps	After 15 minutes
•	Spa light	After 4 hours

2009 Genesis Portable Spa

LTR20091058, Rev. A www.calspas.com