Cambridge Audio 340Razur Front panel display, Loudspeaker connections, 1Digital/Analog indicators

Front panel display

1 2 3 4 2 5

8 2 7 2 6

1Digital/Analog indicators

Indicates the current source input type - digital or analog.

2Decoding mode indicators

Shows the current decoding type: Dolby Digital, Pro Logic II or DTS. In conjunction with the Output Channel indicators these give full details of the current processing mode.

3Tuner mode indicators

Shows Memory/Store active, Stereo mode active, AutoScan active and RDS On.

4Tone control indicator

Lights when Bass and Treble controls are active i.e. have been set to anything other than 0dB (flat) position.

5Output channel indicators

Shows the currently active channels depending on decoding mode and source material. Icons lit indicate active channels in the source material. Icons with a box around them indicate actual channels being output separately.

6Frequency type

Indicates the tuned frequency in AM or FM Tuner mode.

7Main information display

Loudspeaker connections

To avoid damaging the speakers with a sudden high-level signal, be sure to switch the power off before connecting the speakers. Check the impedance of your speakers. Speakers with an impedance of between 4 and 8 ohms (each) are recommended.

The coloured speaker terminals are positive (+) and the black speaker terminals are negative (-). Make sure correct polarity is maintained at each speaker connector or the sound can become weak and “phasey” with little bass.

Prepare the speaker cords for connection by stripping off approximately 10mm (3/8”) or less (no more than 10mm, as this could cause a short- circuit) of the outer insulation. Twist the wire tightly together so there are no loose ends. Unscrew the speaker terminal knob, insert the speaker cable, tighten the knob and secure the cable.

Note: All connections are made via loudspeaker cable, except if using an active subwoofer which would be connected via a standard RCA phono cable. Banana Plugs (4mm standard) connected to the speaker cable are recommended for direct insertion into the speaker terminals.

Please refer to the ‘Speaker configuration’ section of this manual for more information on setting up your speakers.

Shows the current source selected, also the surround mode and station name/frequency when in tuner mode etc.

8Balance indicator

Lights when the Front Left and Right speaker outputs have been set to different levels in the OSD, i.e. a balance adjustment has been made.

Display examples

Powered

subwoofer

Phono/RCA cable

Front left	Front right
speaker	speaker

Front centre

speaker

- Indicates a 5.1 Dolby Digital source being played back as 5.0 (Sub off).

LFE indicates a low frequency effects channel is present in the source

material. When this icon isn’t boxed it indicates the LFE channel is not

being reproduced separately, but is instead being directed to the Left

Optical

Out

Do not obstruct ventilation. Ne pas obstruer la ventilation. Ventilation nicht verschließen.

		Component Video In					TV/Mon Out
	In 1		(Assignable)	In 2			Component Video
Cr/Pr	Cb/Pb	Y	Cr/Pr	Cb/Pb	Y	Cr/Pr	Cb/Pb	Y
			Speaker Impedance 4-8 Ohms

and Front Right speakers.

Coax Out

SL C

Centre	Sur	Sur	Front	Front
	Right	Left	Right	Left

- Indicates a 2.1 output created in the digital domain from analog input

material.

SR	SW	Subwoofer	5.1
5.1 Direct In
		Out

Surround	Surround
left speaker	right speaker

8