Cambridge Audio 340Razur user manual Remote control, azur 340R

azur 340R

Remote control

Insert the supplied AAA batteries to activate the supplied remote control.		Audio Type
For full details of the various adjustment functions available from the		Selects between analog or digital audio input for the current source.
remote, refer to the later sections of this manual.
	On	Stereo
		For listening in 2-channel stereo.
Press to switch the unit on.
	Standby	Stereo + Sub
		2-channel stereo and digitally created subwoofer channel.
Switches the unit into Standby mode. Press the On button to exit
Standby mode.		PLII, DD/DTS, DSP Modes

ENGLISH

DVD, Video 1, Video 2, Video 3, Tape MD/CDR, CD/Aux

Press the corresponding button to change the input source.

See button details as listed in the ‘Front panel controls’ section on the previous page.

Tuner FM/AM	On
Selects Tuner mode. Pressing again to toggle between FM
	DVD
and AM modes.
PTY (Program Type Search)	Video 3
Press to search by program type when in Tuner mode.	Tuner FM/AM
Refer to the ‘Operating instructions’ section of this
manual for more information.	Stereo/Mono
APS (Auto Program Search)	OSD

Standby

Video 1 Video 2

Tape/MD/CDR CD/Aux

PTYAPS

Store Mode

Display

DRC (Dynamic Range Control)

Press to rotate through four dynamic range settings when listening to Dolby Digital/DTS movie soundtracks. Refer to the ‘Operating instructions’ section of this manual for more information.

LFE Trim

Press to trim (adjust the level of) the Low Frequency Effects channel using the Volume up/down buttons.

Sub On/Sub Off

Hold down for 4 seconds to allocate and memorise radio stations automatically.

Stereo/Mono

When listening to the FM tuner, press to alternate between stereo and mono modes.

Store

Press to store the current frequency when in Tuner mode.

Bass/Treble

Audio Type

Vol

Enter

Vol

Mute

Stereo Stereo + Sub

The Sub On/Off buttons perform temporary muting of the Subwoofer without affecting the bass management or speaker settings. To make permanent settings to the speaker options including the Subwoofer, use the ‘Speaker Config Menu’ in the On Screen Display (OSD).

Note: Selecting a new decode mode always cancels sub mute.

Also, hold down and then press the volume up and down buttons to adjust the overall sub level if desired.

Mode

Press to select Auto/Manual or Preset tuning when in Tuner mode.

OSD (On-screen Display)

Press to access the on-screen set-up menu when connected to a monitor/screen via composite or S-video connections.

PL II	DD/DTS	DSP
DRC	LFE Trim	Sub On
5.1 Direct		Sub Off

5.1 Direct

Selects the 5.1 Direct input.

The above button descriptions are naturally brief. Please refer to the ‘Operating instructions’ section of this manual for more information on the relevant functions implemented.

Display

Press to view the current source material and decoding mode. When listening to FM with RDS, press to cycle round various RDS information modes.

Volume

Increase or decrease the volume of the AV receiver output. Also used as up/down in the OSD setup menu.

Tune / Left & Right

Press the right arrow to increase tuner frequency/change preset. Press the left arrow to decrease tuner frequency/change preset. Also used to scroll left/right in the OSD setup menus.

Enter

Used in the OSD setup menu.

Bass/Treble

Press for bass/treble adjustment, using the Volume up/down buttons.

Mute

Mutes the audio on the AV Receiver. Press again to cancel mute.

7