Audio setup menus
Speaker Setup |
|
SPDIF Output | RAW |
LPCM Out | 48K |
HDMI Audio | PCM |
PRO Logic II |
|
Go To Speaker Setup Page |
|
|
|
With the Audio setup menu selected, use the | and | arrows to move | |
to the desired | arrows | ( | ) to |
adjust the settings and press the Enter button to confirm your selection. See below for the Audio Setup menu structure:
azur 540D V2
Large = Speakers with an extended low frequency response of |
| ENGLISH |
approximately |
| |
|
| |
|
| |
Small = Speakers with a less extended low frequency response of |
|
|
approximately |
|
|
or satellite speakers). |
|
|
Setting each speaker allows the 540D V2 to perform what is called Bass |
|
|
Management and to direct low frequency bass from music and the Low |
|
|
Frequency Effects channel of surround sound material away from |
|
|
speakers not able to reproduce it and to the subwoofer channel instead. |
|
|
Front, Centre and Rear Speakers
These settings allow selection of ‘Large’ or ‘Small’ speaker ‘size’ as described above.
Note: Only the three configurations All speakers Large, Large Fronts /
Menus
Speaker Setup
SPDIF Output
LPCM Out
HDMI Audio
Pro Logic II
Settings
Downmix
Front Speaker
Centre Speaker
Rear Speaker
Test Tone
SPDIF Off
RAW Bitstream
PCM Stereo
48k
96k
Follow SPDIF PCM stereo
Pro Logic II
PL II Mode
Stereo Off
Large Small
Large Small
Large Small
On
Off
On
Off
Music
Movie
Centre with Small Rears and All speakers Small are supported by the 540D V2.
Test Tone
With the unit in Stop mode, the disc drawer open and Downmix set to ‘Off’, select ‘On’ to carry out a test tone procedure. The 540D V2 will then play
SPDIF (and TOSlink Optical) Output
Three options are available: Off, Raw Bitstream and PCM Stereo.
If PCM Stereo is selected the digital output will always be Digital PCM Stereo (LPCM) for use with a DAC, recording to a MD or
If Raw bitstream is selected the output will either be PCM Stereo for Stereo disc/soundtracks or a
DISC | SETTING | PCM | Raw |
| |||
|
|
|
|
CD |
| PCM @ 16/44.1 | PCM @ 16/44.1 |
| Downmixed PCM | Raw bitstream for | |
|
| @ 16/48 or 16/96* | surround sound |
|
|
| soundtracks |
Speaker setup
Downmix
Stereo - When in Stereo mode any DD 5.1 or PLII 5.1 content will be downmixed to Stereo and output from the Front Left and Right sockets of the 5.1 output only.
Off - When Off, full 5.1 output will be available (depending on disc).
Note: The 540D V2 also features a separate set of permanent Stereo Outputs that will always output true Stereo (for Stereo material) or downmixed Stereo from 5.1 regardless of the above setting.
If Downmix is ‘On’, only the Front Speaker size and Sub On/Off can be selected.
In the next series of menus for each speaker type, select from ‘Large’ and ‘Small’ for each speaker (‘Large’ and ‘Small’ are used to describe each speaker in terms of bass response and do not necessarily reflect the actual physical size of the speaker).
PCM @ 16/48 or 16/96* |
for stereo soundtracks |
*48kHz or 96kHz depending on soundtrack bit depth and LPCM limit set as below.
LPCM Out
Selects whether the SPDIF LPCM output from DVDs can be at 96kHz maximum sample rate (if the disc supports it) or will be downsampled to 48kHz maximum. Some equipment can only support a 48kHz maximum sample rate and hence it can be useful to set this maximum limit. CDs are 16/44.1 so are unaffected.
13
