Cambridge SoundWorks MC650HD manual Speaker Mounting, Hanging the speaker on the wall

Pull the speaker logo straight out to remove it. Use a philips screwdriver to gently tighten the lock screw concealed in the hole behind the logo to secure speaker to the bracket. Do not over-tighten. It only requires slight pressure! Pay attention to the wire location so that the screw does not penetrate the speaker wire. Install the logo so that the text is upright.

SPEAKER MOUNTING

The MC650HD may be wall mounted or placed horizontally on a table top as a center-channel using the included hardware. Matching floor and table-top stands are available

separately from Cambridge SoundWorks.

Hanging the speaker on the wall:

The MC650HD may be mounted either vertically or horizontally using the supplied wall bracket. Method #1 is recommended. Use Method #2 if there is insufficient

clearance for Method #1.

Method #1 – Use this method when mounting the speaker vertically when you have at least 21" clearance above the top of the wall mount bracket. Use this method whenever mounting the speaker horizontally.

1.Using the wall mount bracket as a guide, mark at least four locations for mounting screws. It is best to use the holes at the four outermost corners. If concealing the wiring in the wall, position the bracket so that the wire exits the wall through the large hole in the center of the bracket. The wire should extend through the bracket approximately 12". Drill a 1/4" diameter hole and install wall anchors in each location. Refer to the instructions in the Appendix for proper use of the Toggler brand anchors included with this speaker.

2.Attach the mounting bracket securely to the wall using four #10 screws.

3.Attach the wire to the speaker terminals. Slide the speaker on the bracket from the top while guiding the wire through the channel between the speaker and bracket.

4.

4.

1.

3.

2. 5.

Note: Screw is already installed within speaker. Use philips screwdriver to tighten. (See #4)

6