Operating Instructions and Parts Manual

CHN71500

 

 

Set-Up (Continued)

Loading / Unloading The Tool

Always disconnect the tool from the air supply before loading/unloading fasteners. Choose which type of fastener you want to use for you project. Additional fasteners can be found at major home centers.

Loading the Tool

1.Push the latch button. Pull back on the magazine cover fully.

2.Insert a stick of pins into the magazine under the automatic nail length plate. Make sure pointed ends of pins are resting on bottom ledge of magazine when loading. Make sure pins are not dirty or damaged. Pins are marked for direction of loading.

3.Push the magazine cover forward until latch engages.

Unloading the Tool

1.Push the latch button. Pull back on the magazine cover fully.

2.Remove the pins from the magazine.

3.Push the magazine cover forward until latch engages.

4.Always unload all fasteners before removing tool from service. Unloading is the reverse of loading, except always disconnect the air supply before unloading.

Installing No-Mar Tip

1.Disconnect air supply from nailer.

2.Carefully place no-mar tip over the end of work contact element.

3.Check that the WCE and trigger move up and down freely without sticking or binding.

Removing No-Mar Tip

1.Disconnect air supply from nailer.

2.Pry no-mar tip away from the work contact element.

Figure 8 - Loading the Nailer

Work Contact

Element

No-mar Tip

Figure 9 - No-mar Tip

10www.chpower.com