Operating Instructions and Parts Manual | CHN71500 |
|
|
Important Safety Information (Continued)
Never use gasoline or other flammable liquids to clean the nailer. Never use the nailer in
the presence of flammable liquids or gases.Vapors could ignite by a spark and cause an explosion which will result in death or serious personal injury.
h.Avoid using the nailer when the magazine is empty. Accelerated wear on the nailer may occur.
Do not modify or disable the Work Contact Element (WCE). Do not tie or tape the WCE
or trigger in a depressed position. Death or serious personal injury could result.
Always check that the Work Contact Element (WCE) is operating properly.A nail could
accidentally be driven if the WCE is not working properly. Personal injury may occur.
Do not touch the trigger unless driving nails. Never attach air line to nailer or carry nailer while touching the trigger.The tool could eject a fastener which will
result in death or serious personal injury.
Service
a.Tool service must be performed only by qualified repair personnel.
b.When servicing a tool, use only identical replacement parts. Use only authorized parts.
c.Use only the lubricants supplied with the tool or specified by the manufacturer.
Disconnect air supply and release tension from the pusher before attempting to clear jams because fasteners can be ejected from the front of the nailer.
Personal injury may occur.
Air Source
a.Never connect to an air source that is capable of exceeding 200 psi. Over pressurizing the tool is able to result in bursting, abnormal operation, breakage of the tool or serious injury to persons. Use only clean, dry, regulated compressed air at the rated pressure or within the rated pressure range as marked on the tool. Always verify prior to using the tool that the air source has been adjusted to the rated air pressure or within the rated
b.Never use oxygen, carbon dioxide, combustible gases or any bottled gas as an air source for the tool. Such gases are capable of explosion and serious injury to persons.
Air compressors providing air to the nailer should follow the requirements established
by the American National Standards Institute Standard
Save These Instructions
Do Not Discard
Unpacking
After unpacking the unit, inspect carefully for any damage that may have occurred during transit. Check for loose, missing or damaged parts. Make sure to tighten fittings, bolts, etc., before putting unit into service. Check to be sure all supplied accessories are enclosed with the unit. In case of questions, damaged or missing parts, please call
Contents
uPin Nailer
u3/4 inch, 23 gauge headless micropins
uOperating Instructions
uWarranty Card
uCarry Bag
uWrenches
Additional Items Not Included
uCompressor (must be able to maintain a minimum of 60 psi when the nailer is being used)
uAir hose
uSmall tool for clearing jams
uThreadlock glue
uANSI Z87 eye protection
uHearing protection and other personal protective equipment as required
Assembly
This tool comes fully assembled.
The DANGER, WARNING, CAUTION, and NOTICE notifications and instructions in this manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
6www.chpower.com