Operating Instructions and Parts Manual

CHN71500

 

 

Glossary

Become familiar with these terms before operating the unit.

ActuatE (Tool) — To cause movement to the tool’s component(s) intended to drive the fastener.

ACTUATION SYSTEM —­The use of a trigger, work contact element (WCE) and/ or other operating control, separately or in combination or sequence, to actuate the tool.

Air Inlet ­— The opening in which the compressed air supply is connected, usually by means of a threaded fitting.

Fasteners ­— This pin nailer uses 23g Pin Nails ranging in size from 3/8 inch to 7/8 inch.

Magazine — The part of the nailer that holds the Fasteners.

Maximum Air pressure — The maximum allowable pressure of compressed air, as specified by the manufacture, for operating the tool.

No-mar tip — The no-mar tip is designed to eliminate marks caused by the Work Contact Element (WCE) (see Figure 4). The no-mar tip may be removed if not required (See REMOVING NO-MAR TIP) or when a slightly deeper countersink is preferred. Simply slide the no-mar off the WCE.

psi (Pounds per Square Inch) —Measurement of the pressure exerted by the force of the air. The actual psi output is measured by a pressure gauge on the compressor.

Quick coupler —­A quick coupler is designed to work in combination with a quick plug to quickly and easily join a pneumatic tool to an air hose (see Figure 2).

Quick Plug — A quick plug is designed to work in combination with a quick coupler to quickly and easily join a pneumatic tool to an air hose (see Figure 3).

Regulator ­— A device used to control air pressure to an air operated tool

Thread lock Glue — A locking glue that is applied to the screw threads before installing. Prevents the screws from working loose during tool operation.

Figure 2 - Quick Coupler

Figure 3 - Quick Plug

No-mar

Tip

Figure 4

www.chpower.com 7