|
|
|
| FP2040 | |
Installation | Handle |
|
| ||
(Continued) |
|
|
| ||
|
|
|
| ||
! DANGER |
|
| ON/OFF Switch | ||
Improper use of |
|
|
|
| |
grounding plug can result |
|
|
| ||
in a possible risk of |
|
|
|
| |
electrical shock! |
|
| Regulator | ||
! DANGER | Do not use a |
|
|
| |
grounding adapter |
|
|
| ||
with this product! |
|
|
|
| |
2. If repair or replacement of cord or plug |
|
|
| ||
is necessary, do not connect grounding | Safety Valve |
|
| ||
wire to either flat blade terminal. The |
|
|
| ||
wire with insulation having an external | Drain Petcock |
|
| ||
surface that is green (with or without |
|
| |||
|
|
| |||
yellow stripes) is the grounding wire. |
|
|
| ||
| Never connect | Figure 2 - Unit Identification |
|
| |
! WARNING |
|
|
| ||
green (or green and | device occurs, it may be necessary to |
| |||
yellow) wire to a live terminal. | |||||
| Do not attach air | ||||
operate compressor from a 120 volt, 20 |
| ||||
|
| ! CAUTION | |||
3. Check with a qualified electrician or | amp circuit. | chuck or other tool | |||
serviceman if grounding instructions | to open end of hose until | ||||
| |||||
| been completed and unit checks OK. | ||||
are not completely understood, or if in | Operation | ||||
IMPORTANT: Do not operate | |||||
doubt as to whether product is | |||||
properly grounded. Do not modify | Regulator - The regulator controls the | compressor before reading instructions | |||
or damage may result. | |||||
plug provided; if it will not fit outlet, | amount of air pressure released at the | ||||
|
| ||||
have proper outlet installed by a | hose outlet. | 1. Turn regulator fully clockwise to | |||
qualified electrician. | ASME Safety Valve - This valve | open air flow. |
| ||
|
|
|
| ||
WIRING |
| automatically releases air if the tank | 2. Turn switch to OFF position and plug | ||
| pressure exceeds the preset maximum. | ||||
| in power cord. |
| |||
|
| Handle - Designed to move the |
| ||
! CAUTION | Overheating, short |
|
| ||
compressor. | 3. Turn switch to ON position and run | ||||
circuiting and fire | |||||
damage will result from inadequate | Drain Petcock - This valve is located on | unit for 5 minutes to break in the | |||
wiring, etc. |
| the bottom of the tank. Use this valve | pump parts. |
| |
|
|
| |||
NOTE: 120 volt, 15 amp units can be | to drain moisture from the tank daily | 4. Turn regulator knob fully | |||
operated on a 120 volt circuit under the | to reduce the risk of corrosion. | ||||
counterclockwise. Compressor will | |||||
following conditions: | Reduce tank pressure below 10 psi, | ||||
build to maximum preset pressure | |||||
a. No other electrical appliances or lights | then drain moisture from tank daily to | ||||
and shut off. |
| ||||
are connected to the same branch | avoid tank corrosion. Drain moisture |
| |||
|
| ||||
circuit. |
| from tank(s) by opening the drain | 5. Turn regulator knob clockwise to | ||
b. Voltage supply is normal. | petcock located underneath the tank. | cause air to bleed off. Compressor | |||
c. Circuit is equipped with a 15 amp | LUBRICATION | will restart at a preset pressure. | |||
circuit breaker or a 15 amp slow blow | 6. Turn regulator knob | ||||
fuse. |
| This is an oilless product and DOES | |||
| counterclockwise to shut off the air | ||||
If these conditions cannot be met or if | NOT require lubrication to operate. | ||||
and turn switch to Off position. | |||||
nuisance tripping of current protection |
| ||||
|
|
| |||
|
|
| Extension cords for 120V/8 Amp Unit |
|
|
|
| ||
Length of Cord (ft) | 25 | 50 | 100 | 150 | 200 | 250 | 300 | 400 | 500 |
Gauge of Cord | 18 | 14 | 12 | 10 | 8 | 8 | 6 | 6 | 4 |
www.chpower.com
3
