Operating Instructions and Parts Manual

CHN70600

 

 

Set-Up (Continued)

Loading / Unloading The Nailer

Always disconnect the tool from the air supply before loading/ unloading fasteners. Choose which length of fastener you want to use for you project. Additional fasteners can be found at major home centers.

Loading the Tool

1.Pull pusher back until it latches.

2.Insert nail clips into rear loading slot.

3.Press pusher latch button to release the pusher and allow it to engage the nail clip.

Unloading the Tool

1.Pull pusher back until it latches.

2.Dump the nails out the loading slot.

Adjusting The Nail Penetration

The CHN70600 is equipped with an adjustable depth of drive feature, ADC thumbwheel (See Figure 11). This allows the user to determine how deep a fastener will be driven into the work surface.

1.Adjust the operating pressure to a pressure which will consistently drive the fasteners. Do not exceed the maximum operating pressure of the nailer of 120 psi.

2.To increase depth of drive, first pull up on the upper WCE, then rotate thumbwheel to the left (counter-clockwise). To decrease depth of drive, rotate thumbwheel to the right (clockwise). Then release upper WCE into detents which hold the thumbwheel in place after each adjustment.

3.Make sure that the trigger and work contact element (WCE) move freely up and down without binding or sticking after each adjustment.

Adjusting The Direction of the Exhaust

The CHN70600 is equipped with an adjustable direction exhaust deflector. This is intended to allow the user to change the direction of the exhaust. Simply twist the deflector to any direction desired.

Installing and Removing No-Mar / Stud finder Tip

1.Disconnect air supply from nailer.

2.Remove tip from retainer storage location.

3.Carefully place no-mar tip over the end of work contact element.

4.Check that the WCE and trigger move up and down freely without sticking or binding.

NOTE: To remove the tip, reverse the proceedure listed above.

Figure 9 - Loading the Nailer

PressButton

Figure 10 - Nail Bypass Button

Figure 11 - Nail Depth Adjust

Figure 12 - Exhaust Adjustment

No-mar tip

Stud finder

Figure 13 - No-mar / Stud finder Tip installed

www.chpower.com 11