Operating Instructions and Parts Manual

CHN70600

 

 

Important Safety Information (Continued)

Servicea.Tool service must be performed only by qualified repair personnel.

b.When servicing a tool, use only identical replacement parts. Use only authorized parts.

c.Use only the lubricants supplied with the tool or specified by the manufacturer.

Disconnect air supply and release tension from the pusher before attempting to clear jams because fasteners can be ejected from the front of the nailer.

Personal injury may occur.

Air Source

a.Never connect to an air source that is capable of exceeding 200 psi. Over pressurizing the tool is able to result in bursting, abnormal operation, breakage of the tool or serious injury to persons. Use only clean, dry, regulated compressed air at the rated pressure or within the rated pressure range as marked on the tool. Always verify prior to using the tool that the air source has been adjusted to the rated air pressure or within the rated air-pressure range.

b.Never use oxygen, carbon dioxide, combustible gases or any bottled gas as an air source for the tool. Such gases are capable of explosion and serious injury to persons.

Air compressors providing air to the nailer should follow the requirements established

by the American National Standards Institute Standard B19.3-1991; Safety Standard for Compressors for Process Industries. Contact your air compressor manufacturer for information.

Save These InstructionsDo Not Discard

The DANGER, WARNING, CAUTION, and NOTICE notifications and instructions in this manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

Unpacking

After unpacking the unit, inspect carefully for any damage that may have occurred during transit. Check for loose, missing or damaged parts. Make sure to tighten fittings, bolts, etc., before putting unit into service. Check to be sure all supplied accessories are enclosed with the unit. In case of questions, damaged or missing parts, please call 1-800-543-6400 for customer assistance.

Contents

uAngle Finish Nailer

u2-1/2 inch Angle Finish Nails

uOperating Instructions

uWarranty Card

uCarry Bag

Additional Items Not Included

uCompressor (must be able to maintain a minimum of 70 psi when the nailer is being used)

uAir hose

uSmall tool for clearing jams

uThreadlock glue

uANSI Z87 eye protection

uHearing protection and other personal protective equipment as required

Assembly

This tool comes fully assembled.

www.chpower.com 7