Operating Instructions and Assembly Instructions
Airless Paint Sprayers
Assembly Instructions
Tools required:
u3/4 in. or Adjustable Wrench
u5/8 in. or Adjustable Wrench
Assembly
1.Open packaging and check contents.
2.Remove the equipment and all parts from the carton.
3.If sprayer is on stand, no further frame assembly is necessary.
If sprayer is on a cart, install handle in position shown on cover and tighten knobs.
4.Attach high pressure hose to pump and spray gun using a 3/4 inch wrench (See Figure Below). Do not attach suction assembly at this time.
FIgure - Attach hose
Pump Assembly
Hose | Prime/Spray |
Adapter | Valve |
Outlet |
|
Valve | Housing |
Inlet |
|
Valve |
|
Suction |
|
Assembly | Pressure |
| |
| Valve |
Outlet |
|
Prime |
|
Button |
|
| Motor |
| |
Hose |
|
Suction
Bell
Assembly
Preparation
Airless painting systems, unlike most other power tools, require additional care to ensure proper working order. Following these instructions will significantly increase the likelihood of having a positive paint experience.
It is important that the painting equipment is flush/tested EACH time a new job is started. Each pump is tested at the factory with a fluid that must be flushed from the
system prior to painting. It is also required prior to each successive use to flush the storage lubricant from the system. Use the solvent which will be used to clean the equipment. Refer to the paint manufacturer’s recommendations for cleaning fluids.
www.chpower.com