SETTING UP + INSTALLATION

Note: we recommend you keep the transit bracket, braces and screws to immobilise the machine for future transit.

1

2

3

D

Remove the polystyrene base and place the machine near its permanent position (diagram 1).

Carefully cut through the hose retaining clip at the rear of the appliance (diagram 2).

Unscrew the central bolt (A); unscrew the 4 lateral screws

(B)and remove the cross piece (C).Unscrew the two rods D and remove them. Two plastic spacers will fall inside the machine. (diagram 3).

Lean the machine forward, remove the mentioned plastic spacers and remove the plastic bags containing the two polystyrene blocks at the sides, pulling downwards. (diagram 4).

Stop the holes using the plugs that you will find inside the bag containing the instruction booklet. (diagram 5).

4

 

5

 

 

 

The Manufacturers will not be responsible for any possible damage to the machine caused by not following the rules relating to releasing the mechanism. The user is responsible for all costs of installation.

Water connection

The appliance must be connected to the water mains using new hose-sets.

The old hose-sets should not be re-used.

The machine has an inlet hose with 3/4" B.S.P threaded end connection to attach between the threaded connector on the appliance and the cold water supply.

This machine only uses cold water, therefore only one hose is needed to connect to the cold water supply. Do not connect to the hot supply. Cold fill is an energy efficient system. Only the water required for the washing is heated.There is no loss of heat in the pipeline from a hot water tank or boiler to the machine.

WARNING:

DO NOT LEAVE THE PACKAGING WITHIN REACH

OF CHILDREN AS IT IS A POTENTIAL

SOURCE OF DANGER.

Apply the insulation sheet of corrugated material to the base as shown.

Level the machine using the 4 feet.

A

a) Turn the nut clockwise to release the screw adjuster on the foot.

b) Rotate the foot to raise or lower it until it stands firmly on the

 

ground.

B

c) Lock the foot in position by turning the nut

anti-clockwise until it comes up against the bottom of the machine.

 

C

 

min 4 cm

cm

+2,6 mt max

100

max 85 cm

max

 

min 50 cm

26

27