Cannon PROESSIONAL1000 installation instructions Something Wrong With Your Cooker, Problem Check

SOMETHING WRONG

WITH YOUR COOKER

Before contacting your nearest Service Centre/Installer, check the problem guide below; there may be nothing wrong with your cooker.

PROBLEM	CHECK
Slight odour or small amount of smoke	This is normal and should cease after a short period.
when grill/oven used for first time.
Oven cooks too fast or too slow.	Check that the oven setting and shelf positions are as recommended in
	the Cooking Charts. However, it may be necessary to increase or
	decrease the recommended setting slightly to suit your taste.
Ignition does not work:	If all burners fail to ignite:
	Check that sparks appear at the burners; a clicking noise should be
	heard.
	If not;
	(i) Check that the electricity supply is turned on.
	(ii) Check other appliances to see if you have had a power cut.
	If only one burner fails to ignite:
	(i) Check the burner cap is seated correctly.
	(ii) Check the slots in the burner bodies are not blocked with any soap
	residue or cooking soil (see care and cleaning).
	(iii) Check, if the burners have recently been cleaned using a wire wool
	pad eg. "Brillo Pad', ensure that no stray strands are caught on the
	ignitor or burner body.
	NOTE. Satisfactory ignition will only be achieved if all the hotplate
	burners are fitted. In the event of an electricity failure, all burners can be
	lit with a match.
Cannot set an "Auto Cook" programme or	Read the Timer instructions in this book carefully remembering that the
cannot get the timer to turn the oven on or	Cook period is the length of time that the timer will switch the oven(s) on
off at the required times.	as part of an Auto Cooking Programme.
Timer Display shows "0:00" with "AUTO"	The electricity supply to the cooker may have been been interrupted, but
Flashing.	has now come back on again. Set the correct time of day by following
	the instructions given in the timer section of this book.
Fanned oven does not work, but the grill,	The Timer may be set for an Auto Cooking programme. Check the Timer
top oven and hotplate burners work.	to see if "AUTO" is illuminated. If it is, follow the instructions given in the
	Timer section of this book to cancel the Auto Cooking programme.
Oven lamp does not work.	The oven lamp is not covered by the guarantee. The part is easily
	changed (see the section on oven lamp replacement).
	A new lamp may be obtained from our Parts department, (see back
	page).

If there is still a problem contact your local Service office (see back page).

25