Chapter 3
3-2
To prevent the waste ink from leaking, drain the ink, and then remove the maintenance cartridge. Package the
removed maintenance cartridge so that the waste ink does not leak from it.
1) Turn on the [Power] button on the printer.
2) Remove the roll holder from the roll holder slot.
3) Enter the Main menu, and then select "Maintenance" > "Move Printer". Follow the instructions in the
messages, and remove all of the ink tanks.
Put the removed ink tanks in the plastic bag with the ink supply part upward and close the opening.
It takes about 4 minutes to complete the "Move Printer" operation.
- "Move Printer" cannot be selected when "MTCart Full Soon" is displayed.
In this case, replace the maintenance cartridge first.
- Never disconnect the power cord, or open the covers while the "Move Printer" operation is in progress since
this can cancel the operation. If the "Move Printer" operation is canceled while in progress, the printer will
remain in offline mode, and it will not switch to online mode. "Ink
Filling" is performed when the power is turned back on after canceling so repeat "Move Printer" from the
beginning.
4) Once the "Move Printer" operation is completed, turn off the [Power] button.
5) Open the upper cover, check that the heads are capped, and then use the belt stopper to secure the carriage in
place. (PRODUCT DESCRIPTION > Safety and Precautions > Other Precautions > Handling the Printer >
Fixing the carriage.)
When mounting the belt stopper, be careful not to move the carriage by applying too much pressure. If the
carriage moves when the heads are capped, the rubber part of the cap may touch the nozzles on the heads and
damage the printhead.
6) Close the upper cover.
7) Disconnect the interface cable and power cord from the printer.
8) Wait 15 minutes after "Move Printer" and then remove the maintenance cartridge and package them so that
used ink does not leak from them.
Check that used ink is no longer leaking after removing the maintenance cartridge. If it is leaking, install the
maintenance cartridge and wait until leaking stops.
9) Attach the cushioning materials and tape.
10) If the printer is mounted on a stand, remove the printer from the stand.
11) Pack the printer into the packing box, and then put the roll media, ink tank, and optional devices in another
packing box for moving.
Use the original packing material for the printer and optional devices. If it is not available, pack them with a
sufficient amount of cushioning materials.