Chapter 1
1-32
[Paper Settings]
T-1-11
[Paper Details]
T-1-12
Setting Item Description, Instructions
[Cas Paper Type] Choose the type of paper in the Cassette .
[Roll Media Type] Choose the type of roll.
[Chk Remain.Roll] Choose On to print a barcode at the end of a roll before you remove it. The printed
barcode can be used in managing the amount of roll paper left. Choose Off if you prefer
not to print the barcode.
[Roll Length Set] Displayed if Chk Remain.Roll is On .
If a barcode is not printed on rolls, specify the roll length. The roll length is displayed
in meters (1.0 - 91.0 m) or feet (1 - 300 ft.), depending on the setting in Length Unit .
Setting Item Description, Instructions
(The paper type is
displayed here.)
[Roll DryingTime] Specify the time to wait for the ink to dry for each sheet.
[Scan Wait Time] Specify the time to wait for the ink to dry between each scan in
bidirectional printing, in consideration of how quickly the paper
absorbs ink. Note that printing will take longer if you specify a
wait time.
[Feed Priority] Specify exact paper feeding, if desired. Normally, select
Automatic . Choose Print Length if you prefer to feed the paper an
exact amount. However, note that choosing Print Length may
result in slight banding in the direction of Carriage scanning.
[Adjust Length] Displayed if Feed Priority is Print Length .
Adjustment relative to the amount of stretching or shrinkage of the
current paper. For paper that tends to stretch, increase the feed
amount by setting the adjustment value toward +. For paper that
tends to shrink, decrease the feed amount by setting the adjustment
value toward -.
The setting for the amount of paper stretching or shrinkage is
relative. If you access it again later, it will be displayed as 0.00 %.
[Head Height] Adjust the Printhead height.
[Skew Check Lv.] If you print on Japanese Paper Washi or other handmade paper that
has an irregular width, choose Loose for a higher skew detection
threshold, or choose Off to disable skew detection.
However, if paper is loaded askew when detection is Off , note that
paper jams or Platen soiling may occur.
If strict skew detection is required, choose High Accuracy.
[VacuumStrngth] Specify the level of suction that holds paper against the Platen .
[Width Detection] Make this setting when the print size is different from the media
size, for example, when you want to make a print within a frame.
When you select [OFF], the paper width is not detected.