Trimming
You can cut out a portion of a recorded image and save it as a new image file.
Choose [Trimming].
● Press the nbutton, choose the 1 tab and [Trimming], then press the m button.
Choose an image.
● Press the qrbuttons or turn the  dial
Trimming Area | to choose the image and press the m | |
button. | ||
|
Trimming Area Display
Recorded pixels after trimming
Adjust the trimming area.
XA frame will appear around the portion of the image to be trimmed.
XThe original image will display in the upper left and the trimmed image will display in the lower right.
●If you move the zoom lever to the left or right, you can change the frame size.
●If you press the opqr buttons, you can move the frame.
●If you press the l button, you can change the frame size.
●In an image with detected faces, gray frames appear around the faces located in the upper left image. The frames can be
used for trimming. You can switch between frames by turning the Âdial.
●Press the m button.
Save as a new image and display.
●Perform Steps 4 and 5 on p. 138.
•
, 
and 
images cannot be trimmed.
•The width and height ratio of an image that can be changed is fixed at 4:3 (for a vertical image 3:4).
•The number of recorded pixels in a trimmed image will be smaller than before trimming.
139