[ Trimming
You can trim a required portion of a recorded image and save it as new image file.
Select [Trimming].Trimming Area
Trimming Area Display
Recorded pixels after trimming
●Press the nbutton, and select [Trimming] on the 1tab, and press the mbutton.
Select an image.
●Press the qr buttons or turn the  dial, select the image and press the m button.
Adjust the trimming area.XA green frame will appear around the portion of the image to be trimmed.
XThe original image will display in the upper left, and the image after trimming will display in the lower right.
●If you move the zoom lever to the left or right, you can change the size of the frame.
●If you press the opqr buttons, you can move the frame.
●If you press the l button, you can change the size of the frame.
●In an image with a detected face, a gray frame will appear around faces located in the upper left of the frame, and the frame
can be used for trimming. You can switch between frames by turning the  dial.
●Press the m button.
Save as a new image and display.●Perform the operations in Steps 4 and 5 on p. 115.
•
, 
, and 
images cannot be trimmed.
•The width and height ratio of an image that can be changed is fixed at 4:3 (for a vertical image 3:4).
•The number of recorded pixels of an image that has been trimmed will be smaller than the image before trimming.
116