Shooting – Advanced Functions

Program AE

Use the program AE mode to have the camera automatically set the shutter speed and aperture value to match the brightness of the scene.

z The shutter speed and aperture value will show in red on the LCD monitor when the correct exposure cannot be obtained. Use the following methods to obtain the correct exposure and make them appear in white.

•Use the flash

•Change the ISO speed

•Change the light metering mode

Differences between the and Modes.

z The following settings can be adjusted in

mode, but not in

mode.

• Exposure Compensation • White Balance

• ISO Speed

• Flash (Flash on)

• Photo Effects

• Continuous Shooting

•Light Metering Mode • Manual Focus

•AF Frame

z For the correlation between aperture value and shutter speed, see page 76.

Setting the Shutter Speed

When you set the shutter speed in the shutter speed-priority AE mode, the camera automatically selects an aperture value to match the brightness.

Faster shutter speeds allow you to catch an instantaneous image of a moving subject while slower speeds create a flowing effect and allow you to shoot without a flash in dark areas.

z If the aperture value shows in red, the image is underexposed (insufficient light) or overexposed (too much light). Adjust the shutter speed using or until the aperture value display turns to white.

zThe nature of CCD image sensors is such that noise in the recorded image increases at slow shutter speeds. This camera, however, applies special processing to images shot at shutter speeds slower than 1.3 seconds to eliminate the noise, thereby producing high-quality images. Nevertheless, a certain amount of processing time may be required before the next image can be shot.

75