4

5

6

7

8

9

10

11

12

Use [ ] or [ ] to select the type of CALL REJECTION setting (FAX-B840 only) you want.

Press [Start/Copy].

You can select from the followings:

ANONYMOUS: The fax rejects calls from any callers who have blocked their phone/fax number from the Caller ID service.

SELECTIVE: The fax rejects calls from specific phone/fax numbers you place in NUMBER TO REJECT list (see below).

OUT OF AREA: The fax rejects calls from any callers in an area that does not have the Caller ID service.

SHOW IN HISTORY?: Determine if the fax stores phone/fax number for rejected calls in memory.

Use [ ] or [ ] to select ON (YES).

Press [Start/Copy].

If you set to OFF, the setting goes on to the next CALL REJECTION setting.

If you set SHOW IN HISTORY? to YES or NO, the setting returns to ANONYMOUS.

If you set ANONYMOUS or OUT OF AREA to ON, proceed to step 11.

If you set SELECTIVE to ON, register the specific phone/fax numbers you want to reject in NUMBER TO REJECT list. Follow the steps below.

Press [Start/Copy].

Use [ ] or [ ] to select the number of NUMBER TO REJECT list (00-09) under which you want to register the phone/fax number.

Press [Start/Copy].

Enter the phone/fax number using the numeric buttons.

Press [Start/Copy].

To assign additional numbers, repeat the procedure from step 8.To finish, press [Function].

Press [Start/Copy].

Use [ ] or [ ] to select PLAY MESSAGE or DISCONNECT.

Press [Start/Copy].

PLAY MESSAGE: The call will be disconnected after the ALT OUTGOING MSG (see p. 7-1) is played. If you set SELECTIVE to ON in step 5, and want to select this setting, OUTGOING MESSAGE must have been recorded.

DISCONNECT: The call will be disconnected without notice.

Press [Stop] to return to standby mode.

6

DOCUMENTS RECEIVING

6-7