Preparing the Camcorder

Preparing the Camcorder

This section outlines the basic preparations for the camcorder such as attaching a lens and attaching the

 

modular units (handle unit, grip unit, etc.) to the camcorder. The modular units extend the camcorder's

29

functionality so you can choose the configuration that best fits your needs and shooting conditions.

Configuration with handle: Attach

Light configuration with grip

Minimal configuration with

the handle unit to use the built-in

for hand-held shooting

thumb rest. The joystick (A27),

microphone, XLR terminals,

 

control dial (A59) and MAGN.

microphone holder, etc. (A73)

 

button/Assignable button 7

 

 

(A85) are not available to

 

 

operate the camcorder.

Preparing the Lens

As much as possible, attach and remove the lens quickly and in a clean environment free of dust. Refer also to the instruction manual of the lens used.

IMPORTANT

•When attaching/removing a lens, avoid direct sunlight or strong light sources. Also, be careful not to drop the camcorder or lens.

NOTES

•Be careful not to touch the lens mount or any components inside the lens mount area.

•Replace the body cap to the lens mount immediately after removing the lens from the camcorder.

•Keep the body cap clean and free from dust or dirt particles.

Attaching an EF Lens

1 Set the Qswitch to OFF.

2 Remove the body cap from the camcorder and any dust caps from the lens.

3 Attach the lens to the camcorder and turn the lens in the direction of the arrow until it clicks in place.

• EF lenses: Align the red mark on the lens with the red EF Lens mount index mark on the camcorder.

• EF-S lenses: Align the white mark on the lens with the white EF-S Lens mount index mark on the camcorder.