5 To cancel the compensation, return the setting to using the main dial or the

Press the

button or click the main dial.

B or A arrow on the omni selector.

6Shoot the image.

Compensating the Flash Output.

In mode or when [Flash Adjust] is set to [Manual], the flash output can be controlled in three steps, starting from FULL, when shooting. This setting is also active with slave flash photography where multiple flashes are fired at the subject from different positions because the pre-flash does not fire. When an externally mounted flash is attached, its flash output can be controlled (Up to 1/16 from Full, in 1/3 steps).

1Press the button to turn on the LCD monitor.

2Press the button.

3Select using the C or D arrow on the omni selector.

4Adjust the output using the main dial or the B or A arrow on the omni selector.

You can shoot the image right after selecting settings by pressing the shutter button. This screen will appear again, once the image is shot.

e.g. Flash Output

5Press the button or click the main dial.

6Shoot the image.

Some settings are not available with certain Shooting modes. Please refer to Functions Available in Each Shooting Mode (p. 208).

Shooting - Selecting Particular Effects

101