Troubleshooting Guide
If there is a problem, first refer to this Troubleshooting Guide.
Power Source
The battery cannot be recharged.
¡You are using the wrong battery. s Use the dedicated
¡The battery is not properly attached to the charger. s Attach the battery properly to the charger. (p.18)
The camera does not operate even when the <4> switch is set to <1>.
¡The battery is exhausted. s Recharge the battery. (p.18)
¡The battery is not installed properly. s Install the battery properly. (p.20)
¡The memory card slot is open.
sPush in the memory card and close the memory card slot. (p.24)
The access lamp lights or blinks even when the <4> switch is set to <2>.
¡If you set the <4> switch to <2> right after shooting, the access lamp will still light or blink for a few seconds while the image is recorded onto the memory card.
sWhen the camera finishes recording the image to the memory card, the access lamp will stop blinking and the power will turn off.
The battery becomes exhausted quickly.
¡The battery is not fully charged. s Recharge the battery fully. (p.18)
¡The battery’s service life has expired. s Replace it with a new battery. (p.168)
162