Focus Light mode functions, control and switch position are as follows:
OFF MODE (position set at “LIGHT” as in figure to right)
Set in this position to turn Focus Light off.
Single MODE (*)
Push Focus Light switch once and release. The Focus Light will turn on and then turn off automatically as the internal strobe fires; or, if shutter not released, after about 8 seconds.
Continuous MODE (*), (**)
By pushing Focus Light switch continuously, or by turning it to either right or left “Lock” positions while pressing, the Focus Light will turn on and shine continuously until the shutter is released. Then, the Focus Light will turn on again automatically 0.5 seconds after the image is taken.
(*)The Focus Light automatic off function is triggered by the Master Strobe’s flash. Therefore, the Focus Light automatic off function is not recommended for use with
(**) In Continuous MODE, after the shutter is released, the Focus Light will turn off for approximately 0.5 seconds, before turning on again. Therefore, for slow shutter speeds longer than 0.5 seconds, do not use the Focus Light in Continuous MODE, since the light will turn back on while the shutter is still open, exposing the image with light from the Focus Light. Instead use
OFF MODE or Single MODE.
Aperture Value Set Switch Use MethodThe Aperture Value Set Switch positions are as follows:
1.41/2, 2, through to 81/2, 11
“External Auto” is possible when Main Mode Switch is in AUTO
position and the Aperture Value Set Switch position corresponds to the camera system’s Aperture Value settings, when the ISO Sensitivity value is 100.
INON | 37 |
Version 1. October 4, 2003 |
|
Copyright 2002, 2003 by INON America, Inc. | All rights reserved. |