Canon IP5200 quick start Cannot Print Properly from the Digital Camera

Troubleshooting

Problem

Possible Cause

Try This

	A specified period	Disconnect the camera cable and reconnect it.
	of time has elapsed	Depending on the model or brand of your device, you may have to
“Error No.: 2001”
	without receiving a
	response from the	select a print mode compliant with PictBridge before connecting
	digital camera/The	the device.
	digital camera or	You may also have to turn on the device or select Play mode
	digital video	manually after connecting the device to the printer.
	camcorder	Perform necessary operations according to the instruction manual
	connected is not	supplied with your device.
	compatible with	If the error is still unresolved, there is a possibility that you are using a digital
	this printer	camera or digital video camcorder that is not supported by this printer. Use a
		digital camera or digital video camcorder compatible with this printer.
	Automatic Print	See “Eleven flashes” in “Handling Error Messages” on page 77.
	Head alignment
“Error No.: 2500”
	failed

Cannot Print Properly from the Digital Camera

The following are the possible errors that may occur when printing directly from a digital still camera or digital video camcorder*, and the countermeasures to eliminate them.

*Hereafter, the digital still camera and digital video camcorder are collectively called a digital camera or camera.

Camera Error Message	Possible Cause	Try This
Printer in use/Printer	Images are being printed from	Wait until printing ends. The printer automatically starts
warming up	the computer	printing the images from the camera after completing the
		current printing.
	The printer is warming up	Wait until warm-up ends. When it is ready, the printer starts
		printing automatically.
No paper /Paper Error	No paper is loaded	Load paper in either the Auto Sheet Feeder or Cassette which
		you have selected with the Paper Feed Switch on the printer,
		and select Continue*1 in the display on your camera.
	The Paper Output Tray is	Open the Paper Output Tray to resume printing.
	closed
	The Inner Cover is open	Close the Inner Cover and select Stop in the display on your
		camera to stop printing.
Paper jam	A paper is jammed in the	Select Stop in the display on your camera to stop printing.
	printer	Remove the jammed paper, load new paper, and press the
		RESUME/CANCEL button on the printer and retry printing.
Printer cover open	The Top Cover is open	Close the Top Cover on the printer.
No printhead	The Print Head is defective or	Install a Print Head according to the Easy Setup Instructions.
	not installed (The ALARM	If the Print Head has already been installed, remove the Print
	lamp on the printer flashes	Head and reinstall it.
	orange five times.)	If the error still remains, the Print Head may be defective.
		Contact the Customer Care Center.
Waste tank	The waste ink absorber is	The printer has a built-in waste ink absorber to hold the ink
(ink absorber*2) full	nearly full	used during print head cleaning, for example. This error
		message indicates that the waste ink absorber is nearly full.
		You can continue printing for a while by selecting Continue*1 on
		the display on your camera.
		However, because printing is disabled once the waste ink
		absorber becomes completely full and until the waste ink tank
		is replaced, you are recommended to contact the Customer Care
		Center as early as possible. (You will need to replace a particular
		part of the printer.)

81