5
Select the IPv4 tab. In IP Address, enter the IP ad-
dress assigned to the printer, and then enter the sub-
net mask in Subnet Mask and the default gateway in
Gateway Address.
Important
You must specify the IP address here to be able to configure NetWare protocol settings using Remo-
teUI.
6
Click Set.
7
Click OK after the Confirmation message is displayed.
8
Exit imagePROGRAF Device Setup Utility.
Specifying the frame type using the printer Control Panel
1
On the Tab Selection screen of the Control Panel, press or to
select the Settings/Adj. tab ( ).
Note
If the Tab Selection screen is not displayed, press the Menu button.
2
Press the OK button.
The Set./Adj. Menu is displayed.
3
Press or to select Interface Setup, and then press the OK button.
4
Press or to select NetWare, and then press the OK button.
5
Press or to select NetWare, and then press the OK button.
Specifying the Printer's Frame Type
iPF8400SE
User's Guide
Network Setting NetWare Settings
486