Canon LV-7325U Remote Control Unit, Does not work, Wireless Mouse, Function does not, Work, Card

APPENDIX

Problem:	Try these Solution
Remote Control Unit	● Check the batteries.
does not work.	● Check the ALL-OFF switch on the Remote Control Unit is set to “ON.”.
	● Make sure nothing is between the Remote Receiver and the Remote Control Unit.
	● Make sure you are not too far from the projector when using the Remote Control Unit.
	Maximum operating range is 16.4’ (5m)..
Wireless Mouse	● Check the cable connection between the projector and the computer.
function does not	● Check the mouse setting on your computer.
	● Turn the projector on before you turn on the computer.
work.
The image data in	● Check the memory card is inserted properly into PC CARD SLOT.
memory card isn’t	● Check a memory card is set properly.
	● Check MCI mode is selected.
displayed.
	● Check the image data is recorded in the memory card properly.
	● Start the projector again.
The image data can’t	● Check the projector is turned on.
be written in, read	● Check “Card access” in VIEW menu is selected.
	● Check Control Cable for Serial Port (optional) is connected properly.
from the memory
	● Check the memory card is inserted properly into PC CARD SLOT.
card.
	● Check Media Card Imager (supplied) is installed in your computer properly.
	● Check the setting in Media Card Imager (like Serial Port Setting) is set properly.

WARNING :

High voltages are used to operate this projector. Do not attempt to open the cabinet.

45