Canon LV-S2 Computer Input Manual Pc Adjustment, Fine sync, Total dots, Horizontal, Vertical

COMPUTER INPUT

MANUAL PC ADJUSTMENT

This projector can automatically tune to the display signals of most personal computers. However, some computers employ special signal formats which are different from the standard ones and may not be tuned by the Multi-Scan system of this projector. If this happens, projector cannot reproduce a proper image and the image may be displayed as a flickering picture, a non-synchronized picture, a non-centered picture or a skewed picture.

This projector has Manual PC Adjustment to enable you to precisely adjust several parameters to match those special signal formats. This projector has 5 independent memory areas to memorize those parameters manually adjusted. This enables you to recall the setting for a specific computer whenever you use it.

Note : This PC ADJUST Menu cannot be operated when "RGB" is selected on PC SYSTEM Menu (P22).

1	Press the MENU button and the ON-SCREEN MENU will
	appear. Press the POINT LEFT/RIGHT button to move the red
	frame to PC ADJUST Menu icon.
2	Press the POINT DOWN button to move the red frame to the
	item that you want to adjust and then press the SET button. The

Adjustment dialog box will appear. Press the POINT LEFT/RIGHT button to adjust value.

Fine sync

Adjusts an image as necessary to eliminate flicker from the display. Press the POINT LEFT/RIGHT button to adjust value.(From 0 to 31.)

Total dots

The number of total horizontal dots in your picture. Press the POINT LEFT/RIGHT button(s) and adjust number to match your PC image.

Horizontal

Adjusts the horizontal picture position. Press the POINT LEFT/RIGHT button(s) to adjust the position.

Vertical

Adjusts the vertical picture position. Press the POINT LEFT/RIGHT button(s) to adjust the position.

PC ADJUST MENU

PC ADJUST Menu icon

Move the red frame to the item and press the SET button.

Shows status

(Stored / Free) of the

Selected Mode selected Mode.

Press the POINT LEFT/RIGHT button to adjust the value.

Press the SET button at this icon to adjust “Clamp,” “Display area (H/V)” or set “Full screen.”

Current mode

Press the SET button to show the information of the computer selected.

Clamp

Adjusts the clamp level. When the image has a dark bar(s), try this adjustment.

Current mode

Press the SET button at the Current mode icon to show the information of the computer connected.

25

Downloaded from www.Manualslib.com manuals search engine