Canon MVX150i, MVX100i Playing Back with the Built-in Speaker/Headphones, Adjusting the Volume

Playing Back with the Built-in Speaker/Headphones

	E
Selector dial	H (phones) terminal
	Built-in speaker

❍When using the built-in speaker, make sure that “H” is not displayed on the screen. When using the headphones, make sure that “H” is displayed. Change the setting as necessary ( 69).

❍The built-in speaker does not sound when “H” is displayed.

❍Do not connect headphones unless “H” is displayed as it produces noise.

❍The built-in speaker is monaural. Use headphones for stereo sound.

❍The setting has to be done separately for each operating mode. Make sure to change the setting when you have change the operating mode.

Mastering the Basics

Adjusting the Volume

CAMERA PLAY (VCR)

CARD CAMERA CARD PLAY (VCR)

Turn the selector dial up to increase the volume, and down to lower the volume.

• A volume bar appears for 4 seconds.

• You can turn off the volume completely by turning the selector

dial down until [OFF] appears. Turn the selector dial up to increase the volume again.

❍Sound may become distorted when the volume is turned up too high.

❍ The headphone volume can be adjusted in all operating modes.

❍The camcorder retains the setting even if you turn it off (separately for headphones and built-in speaker).

❍See also Using Headphones during Recording ( 69).

37