Transfer Roller Assembly Replacement:
★ Use The Latex Gloves When Replacing The Transfer Roller ★
1.Pull the blue gear from the transfer roller shaft.
2.Grasp the mounting bracket and gently, but firmly pull the transfer roller from the frame. Keep your hand over the top of the shaft to contain the shaft clip in case it pops off. Remove the transfer roller from the frame.
3.Snap the new transfer roller into place. The long end goes towards the resistor and mounting bracket. Use tweezers or a small flathead screwdriver to replace the shaft clip, if necessary.
4.Replace the blue gear onto the shaft with its flat edge facing outwards.
5.Slide the right side shaft end of the transfer roller assembly into the clip.
6.Mount the left side transfer roller bracket on the pick up roller assembly shaft.
7.Press down on the blue gear until it snaps into place.
Internal Access Door Assembly Removal/Replacement:
1.Lift the spring loaded internal access door. Locate and remove the three self tapping mounting screws (one black screw on the far left, two silver screws on the far right).
2.Lift the internal access from the inside of the paper path door.
3.Inspect the four oval rollers on the paper path door. Clean them of any debris, dust or paper and wipe them down with alcohol and a lint free towel.
4.Open the spring loaded arms of the new internal access door and position it on the inside of the paper path door (the shorter arm with the three gears goes toward the right).
Fuser Replacement:
1.Line up the five screw holes on the new fuser and the inside of the paper path door.
2.Pull the left side of the paper path door outward gently, yet firmly and push down on the left side of the fuser until it snaps into place. Install the right side of the fuser in the same manner.
3.Resecure the five collared screws.
4.Close the spring loaded internal access door.
