Additional Information
Playback
During playback there is video noise.
- Video heads are dirty. Clean the video heads (
2).
Playback does not start.
-Load a cassette ( 
27).
-Set the camcorder to 
(
33).
-Tape reached the end (“ 
END” appears on the screen). Rewind the tape ( 
27).
No sound from the
-Open the LCD panel.
-Speaker volume is turned off. Adjust the volume with the [SPEAKER VOLUME] setting ( 
34).
Image will not appear on the TV screen.
- Check again that the camcorder is properly connected to the TV ( 
49).
Tape is running, but image will not appear on the TV screen.
-TV/VIDEO selector on the TV is not set to VIDEO. Set the selector to VIDEO ( 
50).
-Video heads are dirty. Clean the video heads ( 
2).
-You attempted to play back or dub a copyright protected tape ( 
52). Stop playback/dubbing.
Editing
Cannot record with this camcorder video input from an external video device connected using a DV cable. - Wrong signal standard. Refer also to the instruction manual of the connected device.
List of Messages (in alphabetical order)
HANGE THE BATTERY PA K |
|
|
|
|
|
| |
- | Battery pack is exhausted. Replace or charge the battery pack ( |
|
| 17). |
| ||
|
| ||||||
| CHECK THE CASSETTE |
| [AUDIO MODE] |
|
| ||
- | You attempted to dub audio ( |
| 53) on a tape recorded with an audio mode other than [ | 12bit]. | |||
| |||||||
| CHECK THE CASSETTE |
| [BLANK] |
|
| ||
- | You attempted to dub audio ( |
| 53) on a tape with a blank section. |
|
| ||
|
|
| |||||
| CHECK THE CASSETTE |
| [INCORRECT TAPE SPECIFICATION] |
|
| ||
- | You attempted to dub audio ( |
| 53) on a tape recorded in HD (high definition) standard. |
| |||
|
| ||||||
| CHECK THE CASSETTE |
| [REC MODE] |
|
| ||
- | You attempted to dub audio ( |
| 53) on a tape recorded in a recording mode other than SP. |
| |||
|
| ||||||
64