Capresso S9 11b. PROGRAMMING THE CLARIS CARTRIDGE, 11c. REPLACING THE CLARIS CARTRIDGE, Filter No

Models: S8 S9 S7 13215

1 29
Download 29 pages 63.23 Kb
Page 14
Image 14

cartridge (Fig.12).

Insert the cartridge with its tapered end down and the exten- sion piece up. Make sure it fits snugly over the white mesh piece inside the water container. Push down gently (Fig.13).

Close the holder for the cartridge so that it engages in the water tank (Fig.12).

Fill the water tank with fresh cold water and replace.

11b. PROGRAMMING THE CLARIS CARTRIDGE

COFFEE READY.

Open cover for programming (Fig.1,19).

Press the P button until you hear a beep.

PRESS KEY / POWDER QUANTITY.

Press the + button several times until the display shows:

FILTER NO

Press the P button (you will hear a beep). The word NO flashes.

Press the + button once and the word YES flashes.

Press the P button to confirm.

RINSE FILTER / PRESS STEAM.

• Place a large container (approx. 1 liter or at least 22 oz.) under the steam nozzle (Fig. 4) and press the PERMANENT STEAM button (Fig.3,M).

PLEASE WAIT / FILTER RINSING. Water will be pushed through the steam nozzle and will stop automatically. The water might be slightly discolored. Discard water. This procedure activates the Claris cartridge.

FILTER YES

Press the N button.

COFFEE READY

IMPORTANT: If you select "YES" for the Claris Cartridge the function WATER HARDNESS is suppressed and turned off.

11c. REPLACING THE CLARIS CARTRIDGE

The filter is monitored automatically. After approx. 50 liters (approx. 55 quarts) of water, the filter loses its effect. The display will show:

REPLACE FILTER

Attention: The filter should be changed every 2 months if you use less than 50 liters. In this case, no message will appear in the display.

Remove the old cartridge, snap the extension tube onto the new cartridge and install. The old cartridge is environ- mentally friendly. Dispose with regular household trash.

Fill water tank with fresh water.

Open front cover and press the CLARIS button (Fig.3A,R). for a few seconds until you hear a beep.

RINSE FILTER / PRESS STEAM

• Place a large container (approx. 1 liter or at least 22 oz.) under the steam nozzle and then press the PERMANENT steam button (Fig.3,M).

PLEASE WAIT / FILTER RINSING

Water will be dispersed into the container and will stop automatically. When the cycle stops the machine will display

COFFEE READY.

12.MAKING ESPRESSO AND “CREMA COFFEE”

To understand the principles of pressure brewing refer to chapters 4. through 4.3.

14.

Page 14
Image 14
Capresso S9 11b. PROGRAMMING THE CLARIS CARTRIDGE, 11c. REPLACING THE CLARIS CARTRIDGE, Making Espresso And “Crema Coffee”