the tray for approx. 20 seconds and then replace it.
•Place a large container (24 oz.) underneath the coffee spout (Fig.1, 1).
ADD TABLET/ PRESS CLEANING
•Open the ground coffee funnel lid (Fig.1,10) and drop one white tablet into the opening (Fig.23).
•Push the TABLET CLEANING button (Fig.3A,S) again.
•The machine will start the automatic cleaning program by dispensing water in intervals into the container underneath the coffee spout.
•When finished, the display shows EMPTY TRAY and the machine "beeps".
•Remove the tray. There will be water in the tray and in the used coffee container. Empty, clean and replace.
RINSE UNIT
•Place a cup underneath the coffee spout and push the RINSE button (Fig.2,F).
COFFEE READY
•Clean the ground coffee funnel after each cleaning cycle.
•Remove the funnel and rinse under hot water and dry.
•Replace funnel (Fig.21 and 22).
17.2 DECALCIFYING
The machine has an integrated decalcifying program. When the shows UNIT CALCED it is time to decalcify the machine. You can still make coffee. However, it is highly recommended that you decalcify the machine within the next 2 days.
Note: If you use the Claris water cartridge and the message UNIT CALCED is displayed, then your cartridge function is not activated. Follow the instructions in chapter 11a.
Run the decalcifying program only after the machine has been switched off for at least 5 hours and has cooled down completely. IMPORTANT: The decalcifying program must not be interrupted.
DECALCIFYING AGENT:
Only use our special decalcifying tablets. For supplies see chapter 19.
CAUTION: Never use vinegar or any other decalcifying agent. This might damage internal parts of the machine.
Decalcifying Procedure
UNIT CALC
•Remove, empty water tank and replace
•Turn off machine and let it cool down for approx. 5 hours.
•Open cover (3), push and hold the DECALC button (Fig. 3a,T1) until you hear a "beep".
EMPTY TRAY
ATTENTION: Even if the drawer is empty you must remove it for at least 20 seconds. Replace drawer.
AGENT IN TANK
• Remove Water Container. Fill with 20 oz. of water and completely dissolve the contents of one blister pack (2 tablets).
AGENT IN TANK / OPEN TAP / PRESS CALC
•Make sure that the frothing attachment is removed and place a large container under the steam nozzle (Fig. 4).
25.