Carrier 500 T/R Menu 10 General settings, Temperature units C, Sample rate Minutes, PIN code 1111

Menu 10 : General settings

General settings for identifying the unit.

10.1Temperature units >C

		The units that temperatures will be displayed. Either degrees C, or degrees F.
10.2	Sample rate	>10 minutes
		The interval time in Minutes (1, 2, 3,..,15, 20, 25, 30,.., 60 minutes) for storing
		a temperature measurement into memory.
10.3	Vehicle ID	>AB-1234
		16 characters are available for assigning a vehicle identification. It is
		necessary to enter an identification like registration number or chassis number
		in the case of a trailer. The vehicle ID will be shown on every printout in the
		header together with the serial number and Header text.
10.4	Header text	>Abcdef
		16 characters are available for assigning a header tittle (usually the company
		name). The header text will be shown on every print out together with the
		Vehicle ID and serial number.
10.5	PIN code	>1111
		The PIN code is intended to avoid having unauthorised people access to
		changing parameters which can influence a correct recorder operation. Select
		a code between 1111 and 9999. The factory setting is 1111. (digit “0“ is not
		available.)
		Attention : Do not forget to note the new PIN code and store it in a safe
		place. There is no master code available to get later access to the parameter
		menu.
10.6	Correction factor	>+0
		Correction factors from –9 to +9 for calibrating the temperature sensing
		circuitry. To be used with diagnostic procedure “set correction factor”. See
		enclosure D and field diagnostic instructions.
10.7	Serial number	>11200231
		Displays only the serial number of the recorder. The number will be set at
		factory and cannot be changed. The serial number will be on every print out.

Menu 11 : Communication settings

Following settings enable you to configure communication with internal options or external devices.

11.1 COM1 RS-232 port setting

The COM1 RS-232 port can be configured with :

•No protocol

•Third party: light protocol to extract part of the data from the recorder.

•TMS protocol (9,600 Baud): current protocol to extract all data from the recorder.

•DECT protocol: to communicate with optional in-built DECT module.

•GSM protocol: to communicate with optional in-built GSM module.

•TMS protocol (38,400 Baud):

Page 21 62-61138-20 (02/03)