Carrier 52P Competitive Sleeve Preparation, Remove Existing Baffles On, Remove Bottom Seal From

■COMPETITIVE SLEEVE PREPARATION

IMPORTANT: Inspect the wall sleeve thoroughly prior to installation. Manufacturer does not assume responsibility for costs or damages due to defects in the sleeve or improper installation.

Disconnect all power to unit to avoid possible electri- cal shock during installation.

Remove any existing foam baffles that are installed on the outdoor grille if present. See Figure 6.

GE Sleeves Only

Metal Wall Sleeve — Remove metal clip on mounting rail located on left, inside bottom of metal sleeve and discard. See Figure 7.

Plastic Sleeve — Remove bottom seal from plastic sleeve. See Figure 8.

■INSTALLATION OF A CARRIER WALL SLEEVE USING A NON-CARRIER GRILLE

This application has become more common due to pre-manufactured windows with built-in grilles or ren- ovations where a Carrier sleeve is used with an exist- ing non-Carrier grille.

Use of a Carrier wall sleeve with a non-Carrier grille requires installation of an Accessory Baffle Kit, which ensures a good seal between the unit and exterior grille and prevents air recirculation. (See Figures 9 and 10.) Air recirculation is a large contributor to performance loss and premature damage to major components.

BAFFLES

FIGURE 6 — REMOVE EXISTING BAFFLES ON

COMPETITIVE OUTDOOR GRILLES

FIGURE 7 — REMOVE METAL CLIP ON

GE METAL SLEEVE

FIGURE 8 — REMOVE BOTTOM SEAL FROM

GE PLASTIC SLEEVE

FIGURE 9 — ACCESSORY BAFFLE KIT

FIGURE 10 — INSTALLATION COMPLETE

6