Carrier ZC manual Install Casing In Wall, Remove the plastic front Remove the safety screw

INSTALL CASING IN WALL

NOTE

Unit casing should project ½” (13mm) in to room to ensure proper fit of decorative grille.

Remove the two screws that hold the plastic front (one at each side).

Remove the plastic front.

Remove the safety screw.

Be careful not to be injured by the metal parts.

Disconnect the ground wire and remove the unit from the wrapper pulling it by the bottom.

Tip casing to outside. Tip is necessary for draining condensate to the rear of the basepan, to allow for excess condensation run-off. The tip also helps to prevent leakage into the room by allowing excess water to drain away from the building.

The recommended outward tip is 3/16 to 3/8 in. (5 to 10

mm)from inside to outside. This means that back of casing outside the room must be 3/16 to 3/8 in. (5 to 10

mm)lower than the front edge inside room.

16